How to change governor on ez go electric golf cart?

To change the governor on an EZ Go Electric Golf Cart, follow these steps:

1. Locate the governor on your EZ Go Electric Golf Cart. It is typically located on or near the engine or motor.

2. Disconnect the battery to ensure safety while working on the golf cart.

3. Remove any necessary components or covers to access the governor. This may vary depending on the specific model of your golf cart.

4. Find the governor linkage or cables that are connected to the engine or motor. It is usually a metal rod or cable.

5. Disconnect the governor linkage or cables from the engine or motor. This may require loosening or removing screws or bolts.

6. Remove the existing governor from the golf cart. This may require unscrewing or unbolting it from the mounting brackets.

7. Install the new governor in the same location as the old One. Ensure it is securely attached to the mounting brackets.

8. Reconnect the governor linkage or cables to the engine or motor. Make sure they are properly aligned and secure.

9. Replace any components or covers that were removed to access the governor.

10. Reconnect the battery to restore power to the golf cart.

11. Test the golf cart to ensure the governor is functioning properly. Take it for a ride and check that the speed is adjusted according to your desired settings.

Note: It is important to consult the manufacturer's manual or seek professional assistance if you are unsure about changing the governor on your EZ Go Electric Golf Cart.