How to connect remote to electric skateboard?

To connect a remote to an electric Skateboard, follow these steps:

1. Ensure that the remote and the electric Skateboard are both powered on and charged.

2. On the remote, look for a sync button or a pairing button. This button is usually located either on the front or on the side of the remote.

3. Press and hold the sync button on the remote. You should see a Light or indicator on the remote start blinking to indicate that it is in pairing mode.

4. On the electric Skateboard, locate the receiver. The receiver is typically located near the battery or the motor. It may have a small button or a switch.

5. Press and hold the button on the receiver. This will put the receiver in pairing mode.

6. Once both the remote and the receiver are in pairing mode, they will begin searching for each other.

7. When the remote and the receiver find each other, they will automatically pair and sync. The indicator Light on both devices should stop blinking and remain solid.

8. Test the connection by gently pushing the throttle on the remote. You should feel the Skateboard respond and begin to accelerate.

9. If the connection is not established, repeat the above steps and make sure that the remote and the receiver are within close proximity to each other.

Following these steps should help you successfully connect the remote to your electric Skateboard. However, it's important to note that the specific process may vary depending on the brand and model of your electric Skateboard, so refer to the manufacturer's instructions for detailed guidance.