How to hook up electric oil pressure gauge motorcycle?

To hook up an electric oil pressure gauge to a Motorcycle, follow these steps:

1. Start by locating the oil pressure sending unit on your Motorcycle's engine. This is usually found near the oil filter or on the engine block.

2. Disconnect the wire connector from the oil pressure sending unit.

3. Take the wire from the oil pressure gauge sender and connect it to the terminal on the back of the oil pressure sending unit.

4. Use electrical tape or wire connectors to secure the connection and prevent any loose wiring.

5. Mount the oil pressure gauge in a convenient location on your Motorcycle's dashboard or handlebars. Make sure to choose a location that is easily visible while riding.

6. Connect the gauge's power wire to a switched power source on your Motorcycle, such as the accessory or ignition wire. This will ensure that the gauge only receives power when the Motorcycle is turned on.

7. Connect the gauge's ground wire to a suitable grounding point on the Motorcycle's chassis. This will complete the electrical circuit and allow the gauge to function properly.

8. Start your Motorcycle and check the oil pressure gauge to ensure it is displaying the correct readings. The gauge should give you a real-time indication of your Motorcycle's oil pressure while you are riding.

Note: It is important to refer to the manufacturer's instructions for your specific oil pressure gauge and Motorcycle model to ensure proper installation and avoid any damage to your bike's electrical system.