How to install ezgo electric golf cart pedal box assembly?

Installing the EZGO Electric Golf Cart pedal box assembly is a relatively simple process that can be done in a few steps. Here is a step-by-step guide to help you with the installation:

1. Start by locating the pedal box assembly in your EZGO Electric Golf Cart. The pedal box assembly is usually located near the front of the cart, underneath the dashboard.

2. Remove any existing pedal box assembly that may be in place. This can be done by unscrewing the bolts or screws that are holding it in place. Be sure to keep track of these screws as you will need them for the installation of the new assembly.

3. Take the new pedal box assembly and position it in place. Align the screw holes on the assembly with the corresponding holes on the cart's frame.

4. Insert the screws or bolts that were previously removed into the screw holes of the new assembly. Tighten them securely using a wrench or screwdriver.

5. Once the pedal box assembly is securely in place, test the pedals to ensure that they are functioning correctly. Give the accelerator pedal a few pushes to make sure it moves smoothly and without any issues.

6. Lastly, double-check all the screws and bolts to make sure they are tightened properly. This will ensure that the pedal box assembly stays in place during use.

By following these steps, you should be able to successfully install the EZGO Electric Golf Cart pedal box assembly. If you encounter any difficulties or have any questions, it is always recommended to consult the user manual or contact a professional for assistance.