How to replace electric golf cart wiper switch?

To replace the Electric Golf Cart wiper switch, follow these steps:

1. Start by turning off the golf cart and removing the key from the ignition to ensure safety.

2. Locate the wiper switch on the golf cart. It is usually located on the dashboard or near the windshield.

3. Use a screwdriver or a wrench to remove any screws or bolts holding the old wiper switch in place. Set aside these screws or bolts in a safe place.

4. Carefully disconnect the wiring harness connected to the old wiper switch. Take note of how the wires are connected to ensure proper installation of the new switch.

5. Take the new wiper switch and connect the wiring harness to the corresponding terminals. Refer to the user manual or manufacturer's instructions if necessary.

6. Once the wiring is properly connected, secure the new wiper switch in place using the screws or bolts removed earlier.

7. Double-check that all connections are secure and the switch is properly installed.

8. Turn on the golf cart and test the new wiper switch to ensure it is functioning correctly.

Remember, if you are unsure about any step or encounter any difficulties, it is recommended to consult the golf cart's user manual or seek assistance from a professional.