How to test electric choke assembly on a motorcycle?

To test the electric choke assembly on a Motorcycle, follow these steps:

1. Start by locating the electric choke assembly on your Motorcycle. It is typically mounted near the carburetor.

2. Ensure that the Motorcycle is in neutral and the engine is turned off.

3. Check the wiring connections of the electric choke assembly to make sure they are secure. Loose or damaged connections can cause the choke to malfunction.

4. Turn the ignition key to the "On" position without starting the engine. This will power up the electrical system of the Motorcycle.

5. Observe the position of the choke plate. It should be closed when the engine is cold and open when the engine is warm.

6. Turn on the engine and let it idle for a few minutes. The choke plate should gradually open as the engine warms up.

7. If the choke plate remains closed or partially closed even when the engine is warm, it indicates a faulty electric choke assembly.

8. To further confirm the issue, you can use a multimeter to test the electrical connections. Set the multimeter to measure resistance and check the resistance across the electrical terminals of the choke assembly. Consult the Motorcycle's service manual for the specific resistance values.

9. If the resistance readings are outside the specified range or there is no continuity, it indicates a faulty electric choke assembly that needs to be replaced.

Remember to always consult your Motorcycle's service manual for specific instructions and values related to testing and troubleshooting your electric choke assembly.